Inter-fab BYOS 1 SLIDE SYSTEM, Инструкции по сборке/установке

Страница: 8 / 20

I N S T A L L A T I O N I N S T R U C T I O N S B Y O S 1 S L I D E
6 BYOS-IM Rev. 08/15 (SBK-BYOS INSTAL)
1. 3/8" Drive Ratchet
2. 3/4” Socket
3. 3/4" Box End Ratchet Wrench
4. 9/16" Socket
5. 9/16" Box End Ratchet Wrench 6. Torque Wrench
7. Angle Finder
8. Tape Measure
9. 48” Level
STEP ONE: Preparing site area for BYOS slide system.
First, Level the hill substrate to the approximate final grade.
TIP:
• The exit section should be supported at the fiberglass
landing plate. (Fig. 1) The exit plate can simply rest
upon the substrate or be drilled from the side and
bolted to a bracket. (not supplied)
NOTE: Build the support for the exit landing in
the correct orientation and at the correct
height prior to setting the fully assembled slide
in place. The exit point of the flume can be no
higher than 20” above the water.
STEP TWO: Flume assembly.
Starting with the exit section, assemble the slide on the
ground, right side up along actual pathway where the slide will
reside. (Be careful not to scratch the slide) Attach the exit
section anchor support, followed by the next flume section in
the correct order of the slide pathway. To help identify the
flume sections for the correct order of assembly, there are
stickers attached at each flange end of each flume section.
For example, attach the letter A end of the exit section to the
letter A end of the next flume section of your custom BYOS
slide. (Fig. 2 - sample only) Attach the anchor supports in
the specified locations as you build uphill and away from the
pool. Stickers are attached to the side of the flange connection
that the anchor support will connect to.
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Landing Plate
Fig. 1
LIST OF REQUIRED TOOLS
Tools required for assembly and installation of BYOS slide:
NOTE: Anchor support locations are noted on a separate sheet (included) that is
specific to your exact slide design. There are stickers attached to the correct flume
piece to indicate which side of the flange you need to connect the anchor support to.
Fig. 2
F’s
E’s
D’s
C’s
B’s
A’s
EXIT SECTION