I N S T A L L A T I O N I N S T R U C T I O N S B Y O S 1 S L I D E
4
BYOS-IM Rev. 08/15 (SBK-BYOS INSTAL)
SLIDE PLACEMENT
If the slide meets the pool edge at an angle, then the outside curve “Pivot A” has to be at
the pool edge. Refer to Diagram D & E below.
If the slide meets the pool edge straight on, then the end of the exit section should be parallel
with the pool edge. Refer to the Diagram F below.
NOTE: The exit point of the flume can be no higher than 20” above the water.
DIAGRAM D
(NOT TO SCALE)
DIAGRAM E
(NOT TO SCALE)
DIAGRAM F
(NOT TO SCALE)
3” MINIMUM
OVERHANG
3” MINIMUM
OVERHANG
3” MINIMUM
OVERHANG
