I N S T A L L A T I O N I N S T R U C T I O N S B Y O S 1 S L I D E
8
BYOS-IM Rev. 08/15 (SBK-BYOS INSTAL)
Fig. 7
Fig. 8
Fig. 4
Fig. 5
Fig. 6
STEP THREE: Entry section anchor assembly.
The BYOS ESA COMBO Entry Section Anchor consists of 1 upright, 1 right support arm and
1 left support arm. The assembly is attached to the BYOS Entry Section with the hardware
kit BYOS-101 COMBO. (Fig. 4)
Carefully turn the BYOS Entry Section upside down (on cardboard) and set the anchor
upright into position as shown in Fig. 5.
Using 4 each 3/8”x1” bolts, attach the anchor to the entry section. Use a flat washer on
each side of the part and anchor. Pass the bolt through from the outside of part toward
the underside and add a lock washer and a nut to each bolt. Hand tighten only. (Fig. 6)
Attach right and left arms as shown in Fig. 7 and 8. The arms are attached at this point
only to the anchor upright using 2 each 3/8”x1” bolts with flat washers, lock washers and
nuts. Hand tighten only. NOTE: The other end of the right and left arms will attach to
flume flanges when connecting the next BYOS section during the slide assembly.
NOTE: Right and Left arms attach to the inside of the ESA COMBO uprights.
