I N S T A L L A T I O N M A N U A L A D R E N A L I N E ™ S L I D E
13
ADR1-IM Rev. 4/16 (ADR-INSTALL)
Fig. 15
STEP FIVE: Assemble the Flume Sections - CONT.
Using hardware kit ADR-102-SS and anti-seize, align the 5 flange holes, place flat washer
over 3/8” bolt, then push completely through the flange. Place a flat washer, lock washer
and nut onto the bolt and just hand tighten at this time.
Next, turn the upper flume upright on its leg and pedestal, repeat the above flange-to-flange
bolting process. (See Fig. 15)
Position the upper flume with leg and pedestal about 12’ from the lower flume. Carefully
remove the lower flume fish wire from the red cap and attach the upper flume fish wire.
Bend the end of the wire shut as in Figure 14 on page 12.
Gently pull the vinyl tubing through the flume section with the fish wire. Pull all tubing through
and be careful not to kink the tubing or get it caught between connection flanges as the
parts are bolted together. Leave the fish wire attached to the cap and tubing. This will insure
that the tubing is not pulled back into the flume section during positioning of the slide.
STEP SIX: Attach the Entry Section & Ladder to the Flume
Stand and lean the Entry and Ladder Assembly against the Upper Flume.
The entry section has a small length of 3/8” vinyl tubing and a connector which will be used
in the final assembly to connect to the vinyl tubing from the exit. (See Fig. 16) Do not connect
the 3/8” vinyl tubing at this time. It will be done after the slide is positioned and mounted
to the deck. Gently move the vinyl tubing from both sections to the side. Align the flanges
and connect with only the bottom 3 bolts with hardware from kit ADR-102-SS and anti-seize.
(See Fig. 17) Hand tighten only at this time.
Fig. 16
Fig. 17
