I N S T A L L A T I O N M A N U A L A D R E N A L I N E ™ S L I D E
17
ADR1-IM Rev. 4/16 (ADR-INSTALL)
STEP ELEVEN: Connect the Water Supply System
Connect the bottom 1” PVC Flex Pipe to the customer installed water stub-up, as necessary.
It is recommended that the provided in-line valve be installed between the slide and the water
source so that the water flow can be adjusted as necessary.
STEP TEN: Tighten Leg Receiver Through Bolts
With the slide secured to the deck and flumes aligned and tightened, tighten the six 3/8”x9-
1/2” bolts on the PVC leg to both flumes and entry section.
Check the sliding surface one last time and adjust as necessary. At this time, check and
re-tighten ALL SLIDE CONNECTIONS.
STEP TWELVE: Finishing Steps
• Install protective caps on all exposed bolts.
• Turn water supply on and check water flow.
• Clean Slide and dispose of all debris caused by the installation.
NOTE: It is recommended that after several days of use, all visible bolted connections be
re-tightened as needed.
FINAL INSPECTION / ANNUAL INSPECTION CHECK LIST:
1. Re-measure the depth and width of the water in front of the slide as well as the slide’s
exit height above water to ensure they conform to Diagrams A, B, and C on page 4.
2. Check the slide’s position on the deck and ensure it conforms to the diagrams on pages 5-6.
3. Ensure the slide is securely anchored to the deck and stable.
4. Inspect the runway for visible cracks or tears.
5. Inspect the runway and ensure a smooth, even sliding surface. Ensure the gaskets
between the flanges are compressed uniformly.
6. Inspect the runway for any water leaks and adjust water flow for even water distribution
across sliding surface. Ensure water does not splash outside the runway, and all water
running off the slide falls into the pool.
7. Inspect the slide for any loose or corroded fasteners.
8. Ensure there is a protective rubber cap on all exposed nuts and bolts.
9. Inspect all step-attachment points and ensure the steps are seated on the nylon support
rods correctly.
10. Inspect the ladder handrails for rigidity and attachment. Can they be pulled out of their
sockets?
11. Inspect the slide for sharp edges or protrusions on the ladder, deck flanges, handrails
or runway.
12. Make sure the slide warning label is securely adhered to the slide.
NOTE: this installation is not complete until you, the installer, gives the owner’s manual
to the customer and then reviews the intended use instructions with them.
