FRONT PANEL
The front panel consists of a number of Control elements (switches, knobs, and an LED), plus
several input and output jacks. These are described below.
Controls
[1]
LEVEL 1
- This attenuator reduces the
IN 1
mono audio
level sent to both
MIX
outputs.
[2]
LEVEL 2
- This attenuator reduces the
IN 2
mono audio
level sent to both
MIX
outputs.
[3]
LEVEL 3
- This attenuator reduces the
IN 3L
and
IN 3R
stereo audio level sent to the
MIX
outputs.
[4]
MUTE 1
- In the down position, this switch mutes
IN 1
—
removing it from the
MIX
outputs.
[5]
MUTE 2
- In the down position, this switch mutes
IN 2
—
removing it from the
MIX
outputs.
[6]
MUTE 3
- In the down position, this switch mutes both
IN 3L
and
IN 3R
— removing them from the
MIX
outputs.
[7]
CLIP LED
- This LED lights when the sum of all the inputs
(from the front panel jacks plus the rear panel serial bus)
causes either side of the stereo
MIX
output to clip.
Obviously, the more inputs you feed into Mixup (or the
more Mixups you feed into each other), the greater the
potential to overdrive the Mix bus. So if the CLIP LED
lights, consider reducing the various
LEVEL
knobs to
maintain a clean, unclipped output.
Inputs & Outputs
[A]
IN 1
- Mono audio input 1. Mixup routes the audio from
IN
1
to both the
MIX L
and
MIX R
outputs. It can be muted with the
MUTE 1
switch, and its audio
level is determined by the
LEVEL 1
knob.
[B]
IN 2
- Mono audio input 2. Mixup routes the audio from
IN 2
to both the
MIX L
and
MIX R
outputs. It can be muted with the
MUTE 2
switch, and its audio level is determined by the
LEVEL 2
knob.
[C]
IN 3L
- This is the left side of stereo audio input 3. Mixup routes the audio from
IN 3L
to the
MIX L
output. It can be muted (along with
IN 3R
) using the
MUTE 3
switch, and its audio level
Mixup Manual
7
