Installing Engage® Zone Control System
Engage® Zone Control Installation Manual
600840-000043, rev 1.4
Page 13 of 31
8. Fully tighten the 6 nuts on each manifold.
9. Record the serial numbers for the motor controllers inside the bin units and the gates
they are associated with. You will assign the serial numbers to their associated gates
during configuration, as shown in the example screenshot below. More information will
be given in the Engage® Zone Control Operator’s Guide.
•
Gates 1-4 correspond with the serial number on the leftmost motor controller in the
unit, and gates 5-8 correspond with the rightmost motor controller.
•
Bin 1 is the bin closest to the tractor. Bins 2 and 3 (if applicable) are further away
from the tractor.
Figure 8: Recording serial numbers
