16
ACCESSORIES:
RIL-1 Remote Infrared Illuminator (OPTIONAL):
The optional RIL-1 Remote Infrared Illuminator is compatible for use with the LLC-12 Low Light
Camera for recording in zero light / total darkness. The illuminator provides 940 Nm invisible IR
illumination (invisible to the human eye) for distances of up to 30 feet from the target. It is
completely remote from the System II so that the desired illumination can be brought on the
subject without running wires for long distances. This also reduces the security risk should the
target utilize
Night Vision goggles. If he finds the illuminator, he won’t be able to follow wires to
the camera and destroy the evidence (video).
Programming/Reset Black Button with integrated Receiver/Processor
15 each Infrared LEDS; 1 each Programming LED
Batteries
(8 “AA” Cells) Illuminator Head
Photocell
Illuminator Control Housing
The IR Illuminator uses 8 “AA” batteries for power. This should power the illuminator for about 1
month in the standby mode (waiting for an alarm) with approximately 6 hours of continuous video
illumination when recording. The illuminator should be programmed with the same Video Runtime
as the System II, plus an additional 10 seconds to allow for DVR boot up time, so that the
illumination period will coincide with the recordi
ng times, thereby conserving power only when it’s
needed. The Illuminator only functions during the night, automatically turning off during the day to
conserve batteries. This is accomplished by a photocell. Access to the battery compartment is
found by unscrewing the lower tube from the illuminator head. The batteries can then be
replaced. Replace the batteries only with lithium types, and then screw the tube back into the
case, reversing the above procedure.
Illuminator Receiver / Processor
The Receiver Processor is integrated into the illuminator head. It receives alarm signals from the
sensor and turns on the illuminator to provide covert illumination for the low light camera. The
only programming variable is the illuminator Runtime. To program the Runtime, press and hold
the Programming Button until the
Green LED
comes ON. Immediately after the Green LED
comes ON, release the button and tap in the Runtime Variable. Each time you tap the button the
Runtime is incremented by 10 seconds. (1=10 sec., 2=20 sec., 3=30 sec.
,….6=1 min., 24=4 min.
maximum).
Program/Reset Button
15 Infrared 940 Nm LEDs
Photocell
Green Programming LED
