60
29.2 DISA board
29.3 Caller ID board
The board allows for the identification of incoming call numbers. This information is stored in the call report/
billing system. It the etension has a Ti or a caller ID device, the phone number will be displayed.
Plug the board in CN2,
CN3, CN6 and CN16
Plug the board in CN43, CN44, CN45
and CN46. Adjust the jumper J1 (A-D)
of the ID board as follows:
Open jumper: long lines (high sensibility)
Jumper position 1-2: medium lines
Jumper position 2-3: short lines (low
sensibility)
Adjust the position of the jumper J4 of
the trunk boards and J11 (A,B) of the
main board IC;
For the ID board to function properly,
the programming steps in item 32
should be followed.
You can
either install
an MFP/DTMF
board or FSK.
NOTE!
- The caller ID board features can only be used if your telecom service provider offers caller ID service or
can send MFP, DTMF or FSK signals.
- Some very old carriers´switches send a digit sequence such as 0111111..., 0444444..., 11111..., 44444...
that will be displayed on your LCD. This does not mean that there is an equipment defect with your caller
ID.
The board allows the caller to directly dial the extension number.
Содержание Micro PABX Conecta
Страница 1: ...CONECTA MODULARE i Version handbook 02 07 Compatible Software 6 8...
Страница 14: ...6 CONECTA...