Intel SBCEFCSW, Руководство по установке

Страница: 32 / 62

18
Intel® Server Switch Module SBCEFCSW: Installation Guide
Figure 7. Fibre Channel switch module LEDs
Notes:
1. The illustrations in this document might differ slightly from your hardware.
2. An amber LED is lit when a system error or event has occurred. To identify the error or event, check the
LEDs on the information panel of the switch module and see Table 2 on page 19 for more information.
3. An LED test occurs whenever the switch module is turned on. All LEDs are lit and remain lit for
approximately 10 to 15 seconds and then return to a normal state.
OK: This green LED is at the top of the switch module on the information panel. When this LED is lit, it
indicates that the switch module has passed the POST and is operational.
♥
(heartbeat): This green LED is at the top of the switch module on the information panel. When this LED is
flashing, it indicates the status of the internal switch module processor and the results of the POST.
✏
NOTE
One flash per second indicates that the switch module processor is operating in OK status. Other flash
patterns indicate POST errors. For more information, see Table 2 on page 19
! (Fibre Channel switch fault): This amber LED is at the top of the switch module on the information panel.
This LED indicates that the switch module has a fault. If the switch module fails the POST, this fault LED is
lit.
Port logged-in: There are two green port logged-in LEDs. The port 2 logged-in LED is at the top of port 2,
and the port 1 logged-in LED is at the bottom of port 1. When one of these LEDs is lit, it indicates that there is
a connection (or link) to a device on that port.
Port activity: There are two green port activity LEDs. The port 2 activity LED is at the top of port 2, and the
port 1 activity LED is at the bottom of port 1. When one of these LEDs flashes, it indicates that data is being
received or transmitted (that is, activity is occurring) on that port. The flash frequency is proportional to the
amount of traffic on that port.
Port fault: There are two amber port fault LEDs. The port 2 fault LED is at the top of port 2, and the port 1
fault LED is at the bottom of port 1. When a port fault LED is lit, it indicates that the external port has failed
the internal, external, or online port diagnostics tests that are performed with the SAN Utility or CLI. For more