Intel R2000LH2, Быстрая установка руководство пользователя

Страница: 7 / 20

3
General Installation Process
Install Processor(s) ...continued
D. Install the Processor
CAUTION: The bottom side of the processor has
components that may damage the socket pins
if installed wrongly.
Processor must align correctly with the
socket opening before installation.
DO NOT DROP processor into socket!
Components
Take the processor out of the
box and remove the
protective shipping cover.
CAUTION: When
unpacking a processor,
hold at the edges only
to avoid touching the
golden contact pins.
Save the protective
cover.
A
Note the location of the golden
key at the corner of the
processor.
A
B
C
Orient the processor with the
socket so that the processor
cutouts match the four
orientation posts on the socket.
IMPORTANT!
Before proceeding
further, check your
Intel ® Server System
for disconnected or
loose cables and
components that
may have occurred
during shipping.
6
Remove Processor Heatsink(s)
The heatsink is attached to the server board and/or processor socket with captive fasteners.
Lift the heatsink straight up.
A
B
C
CAUTION: The heatsink has thermal interface material (TIM) on the underside
of it. Use caution so that you do not damage the thermal interface material.
Use gloves to avoid sharp edges.
Using a #2 Phillips* screwdriver, loosen the four screws located on the
heatsink corners in a diagonal manner using the following procedure:
Using a #2 Phillips* screwdriver, start with screw 1 and loosen it by
giving it two rotations and stop. (IMPORTANT: Do not fully loosen.)
Proceed to screw 2 and loosen it by giving it two rotations and stop.
Similarly, loosen screws 3 and 4.
Repeat steps A and B by giving each screw two rotations each time
until all screws are loosened.
OPEN 1st
CLOSE 1st
NO CPU
Processor
Socket
2
3
1
4
A
B
C
7
Install Processor(s)
A. Remove the Cover C. Open the Load Plate
A
B
B. Open the Socket Lever
Repeat step A to
release the lever
on the other side.
Push down the lever handle on the
OPEN 1st side and away from the
socket to release it.
A
B
Open the load plate all the way.
Press the locking lever slightly to raise
the load plate.
A
Remove the cover
as shown
NOTE : Release
the levers in the
order as shown.
FOXC
ONN
LGA20
11 ILM
1756
2
A
B
OPEN 1st
NO CPU
OPEN 1st
A
FOXCONN LGA201
1 ILM 17562
B
Carefully lower the load plate over
the processor.
E. Close the Load Plate
B
C