Done
Task
Section
Estimated Completion
Time
Register your Development Kit to obtain a
Wind River SW license. A license is
required to complete the remaining steps
in this publication.
on page
27
10 minutes to register.
Up to 1 day to receive
license
Install and Build Runtime on Host System
The completion time is highly dependent on the Host System and the
Internet connection speed.
5 - 10 hours
Install base packages for Wind River Linux
5.0.1, Wind River Intelligent Device
Platform XT 2.0, Wind River Workbench
3.3.5
on page 32
2 - 4 hours
Build the runtime software image on the
Host System and copy the image to a USB
flash drive.
on page 40
3 - 5 hours
Install Runtime Image to Target Device
45 minutes
Install the runtime image on the Target
Device.
45 minutes
Total Estimated Time to Complete Installation
6 - 12 hours
Prepare Host System for Wind River Software Installation
Prepare Host
System for
Wind River
Software
Put Runtime
Software on
Flash Drive
Register Target
Device
Install Linux
and Wind River
Packages on
Host System
Build Runtime
on Host
System
Update SPI
Firmware on
Target Device
Install Runtime
on Target
Device
Before you
Begin
Connect
Hardware
Install Ubuntu Linux Updates
The Linux software on your Host System must be current before you install the Wind
River Host Tools software. This section provides instructions to perform this update.
From your Host System command line interface, use the following command to apply
the Ubuntu updates:
sudo apt-get update
Blank line. Do not remove.
Blank line. Do not remove.
Blank line. Do not remove.
Blank line. Do not remove.
Blank line. Do not remove.
Blank line. Do not remove.
4.2
Prepare to Build Your Runtime Image—Intel IoT Gateway Development Kit DK100 Series
Intel
®
IoT Gateway Development Kit DK100 Series
April 2015
Getting Started Guide
Order No.: 330307-007
25
