5.0
Register Your Development Kit
Important:
If you are using an Early Access Development Kit or a Loaner Development Kit from
the Intel Demo Depot, use the 90-day License Authorization Code provided in the
Dear Customer Letter that came with your kit. in this case, you do not need to register
your Target Device. Instead, skip ahead to
Install Linux Packages and Wind River
Linux Host Tools on the Host System
on page 32.
Put Runtime
Software on
Flash Drive
Install Linux
and Wind River
Packages on
Host System
Build Runtime
on Host
System
Update SPI
Firmware on
Target Device
Install Runtime
on Target
Device
Before you
Begin
Connect
Hardware /
Connect Target
Device to Host
System
Connect Target
Device to Host
System
Register
Target Device
Before you begin the installation process, you must register your Development Kit.
The registration process submits a license key request to Wind River to permit you to
download Wind River Development software. You cannot use the Wind River installer
to download the Wind River software without this license.
You will use the login ID and password that you create or use in these steps to access
the Intel Registration Center. On the Intel Registration Center you can see a list of
licensed products and download the installers for those software products.
1. In your Web browser on any computer, go to
https://registrationcenter.intel.com
The following screen is displayed:
Figure 6.
Register a Product
Register Your Development Kit—Intel IoT Gateway Development Kit DK100 Series
Intel
®
IoT Gateway Development Kit DK100 Series
April 2015
Getting Started Guide
Order No.: 330307-007
27
