·
Restart the system. Let the system boot from hard disk and proceed
with normal installation.
COMMAND LINE USAGE
There are new command line switches to support the new features on the
driver AHA152X.ADD.
Universal Parameters
/SN
- Allow synchronous negotiation (DEFAULT).
/!SN
- Prevent synchronous negotiation.
Special Unit Parameters
/BOFF:t
allows the bus-off time to be set to a value between 1 and 15
microseconds. The default value for OS/2 2.x is 4
microseconds and this should be used for most systems.
/BON:t
allows the bus-on time to be set to a value between 1 and 15
microseconds. The default value for OS/2 2.x is 7
microseconds and this value should be used for most
systems.
/D
Allow targets to disconnect from the SCSI bus (DEFAULT).
/!D
Prevent targets from disconnecting from the SCSI bus.
/H:x
Specifies the 486MIS SCSI ID. A number from 0-7 replaces
x. The default ID is 7. If you specify an invalid number, the
default is used.
/PIO
Use programmed I/O to transfer data to/from the SCSI bus.
/Y
Enable parity checking on the SCSI bus (DEFAULT).
/!Y
Disable parity checking on the SCSI bus.
Page 50 486MIS System Board User's Manual
