31
8
Microphone Operation
SEND DTMF SIGNALING
MAIN/SUB BAND SWITCHING
FUNCTION OPERATION THROUGH PA-PD KEYS
You can operate the transceiver by keypad or input desired frequency
and channel through the QHM-04 microphone.
Hold the PTT key; input the desired DTMF signaling by the numeric keys.
Radios is defaulted on Dual receive. In this status, a MAIN icon will be
displayed in the top right corner of the Main frequency band.
Transmission is possible on Main Band only. In stand-by mode, you can
switch Main Band and Sub band by using the A/B key.
This function is valid only when current channel is set with offset frequency.
PRI
:
Add or delete priority channel: In
channel mode, press the key programmed
as PRI function to set priority channel; when the LCD displays
the
current channel is set as priority channel. Repeat above operation, the
disappear, the curent channel is not set as priority channel.
LOW
: Output power setup, in standby, press the key programmed as
as LOW function will change to lower level. When LCD displays HIGH,
the transmitting power on current channel is high. When LCD displays
MID1, the transmitting power on current channel is middle1, When LCD
displays MID2, the transmitting power on current channel is middle 2.
When LCD displays LOW, the transmitting
power on current channel is low.
TONE
: CTCSS/DCS code setup. In stand-by mode, press the key
programmed as TONE function to enable the CTCSS/DCS code setup.
When the LCD display shows the ENC, DEC and CTCSS tone indications,
press the [UP/DOWN] keys on microphone to select CTCSS decode tone.
When the LCD display shows the ENC and DCS tone indications, press
the [UP/DOWN] keys on microphone to select the desired DCS tone.
MHZ
: In VFO mode, press the key programmed as MHZ function;
the MHz digit will start flashing. Press [UP/DOWN] keys to adjust
frequency by 1 MHz step. In channel mode, use
MHz key; channel number will start flashing.
The PA,PB,PC,PD, keys are programmable, they can be endowed with
the following functions.
RPTR:
OFFSET direction setup, in standby,
press the key programmed as RPTR function
to change the offset direction. When LCD displays"+", means plus offset,
when the LCD displays"-", means minus offset.
NOTE
PTT
Main/Sub band switch
UP
DOWN
MIC
Numeric Keys
UP/DOWN lock key
Microphone speaker
