28
7
General Setting
Set the left band and right band as VHF 144-146 MHz (136-174 MHz)
and UHF 430-430 MHz (400-470 MHz) (*) then turn ON this function
to enable Cross Band repeater function.
Press
1.
key to enter function menu.
Switch the selector knob to choose No 44
2.
function. The LCD displays "
X-RPT
"
Press the Main band selector knob, the
3.
LCD displays "
XSTART
".
Press the Main band selector knob, the radio prompt "DU" and the
4.
LCD displays "RPT", then the corss band repeat function is enabled.
Press
1.
key to enter function menu.
Turn the Main band selector knob to choose No. 45-47 menu. The
2.
LCD displays "
COL RED
","
COL GRN
","
COL BLU
"
Press the Main band selector knob to
3.
enter function setup.
Switch the Main band selector knob to
4.
choose wanted value. Each color (Red,
blue and Green) has 32 brightness levels
available..
Press the Main band selector knob or
5.
key to store value and back to
function menu. Press
key or hold
selector knob for over 0.5 second to store
setup and exit.
CROSS BAND REPEAT
LCD BACKLIGHT
Press
1.
key to enter function menu.
Turn the Main band selector knob to
2.
choose No43 menu. The LCD displays "
WIDNAR
"
Press the Main band selector knob to enter function setup.
3.
Switch the Main band selector knob to choose wanted value.
4.
WIDE
: Wide band (25KHz)
MIDDLE
: Middle band (20KHz)
NARROW
: Narrow band (12.5KHz)
Press the Main band selector knob or
5.
key to store value and back to
function menu. Press
key or hold
selector knob for over 0.5 second to store setup and exit.
WIDE/NARROW BANDWIDTH
This function can be enabled only when both bands work on VFO mode.
Press
key to turn OFF Cross Band function.
NOTE
NOTE
When this function is enable, any adjustment of VFO frequency,
will bring same frequency change to both bands. Adjust one gear, the
frequency for both band will increase or decrease one step size value.
Press
1.
key to enter function menu.
Turn the Main band selector knob to
2.
choose No 42 menu. The LCD displays "
VFOTR
"
Press the Main band selector knob to enter function setup.
3.
Switch the Main band selector knob to choose wanted value.
4.
Available Values:
ON
,
OFF
.
Press the Main band selector knob or
5.
key to store value and back to function menu. Press
key
or hold selector knob for over 0.5 second to store setup and exit.
VFO FREQUENCY LINKAGE
