Integral Circuits CC 50 A, Руководство пользователя

Страница: 12 / 32

12
Applying brakes:
(With brake controller)
1. Press and hold the brake button. Throttle will be au-
tomatically reduced to 0% and brake pressure applied
at the set value. (factory setting is 15psi)*
2. Rotate the knob clockwise to increase pressure.
3. Rotate the knob counter clockwise to decrease pres-
sure.
Stopping/slow down:
(Without brake controller)
1. Press the Brake button. Throttle will be reduced to 0%.
The four quadrant motor drive of the CC50A will slow
down the locomotive to a stop on an even surface.**
if you are on an inclined track piece , the locomotive
might continue to slowly creep forward or backward
down the track. You can prevent this by giving a little
bit of throttle in the opposite direction of travel
* Please Note that this is reversed when you set the Brake Button mode to inverted in the
Setup Menu. Not pressing the button operates the brakes in inverted mode. While press-
ing it means you can change the speed.
** When the brake button is set to inverted, releasing the button will stop the locomotive,
while pressing it means you can change the speed.
Warning! Above mentioned
method is only useful for
short stops.
DON’T keep the locomotive
throttled up stationary on an
inclined track piece for too
long. It can cause heat dam-
age to your motors!!
press
+
hold
1.
2. 3.
FWD>
5
psi
press
1.
!
FWD>
15
psi