Integral Circuits CC 50 A, Руководство пользователя

Страница: 10 / 32

10
4. System and Error Messages
User E-STOP:
This message shows when the power button is pressed while the
system is in operation.
It indicates that the locomotive entered the emergency stop state.
This can be cancelled with a push of the brake button.
Dropped handset E-STOP:
This message shows whenever the handset is dropped and been in
freefall for
longer than the period specified in the setup menu. (“fall time” page 17.)
Handset battery low warning:
This message shows whenever the batteries of the handset fall below
a charge voltage of 1.9v . This message is only shown for a short mo-
ment before the handset turns itself off. (safety shutdown)
Immediate recharging of the Handset batteries is adviced.
Overcurrent Warning:
The system triggers this message whenever the internal current limit of
approximately 75A is overstepped. This is a safety feature to prevent
damages to the motor or motor drive due to mechanical blockage or
overburdening of the locomotive.
Please note that the locomotive wont stop when this occurs, but the
internal safety will turn off the drive on a per PWM cycle basis, and
limiting the current.
To dismiss this message you need to rotate the knob of the hand -
set a notch backwards.
Overheat E-STOP:
The system triggers an Cycle STOP whenever the internal temperature
sensors measure a tamperature above the safe zone for the internal
components.
This message can not be dismissed until the locomotive and hand-
set have been power cycled
System cool down before further use is adviced!
E-STOP
User E-STOP triggered
push Brake to reset
E-STOP
TX dropped!
push Brake to reset
TX battery low
Shutting down handset
OVERCURRENT!
overcurrent in motordrive
rotate knob to continue
OVERHEAT!
Motor controller overheat!
turn off system!
User Induced E-STOP:
If you press the power button at any given time
the locomotive will go into an User requested
E-Stop. To cancel this you need to push the
brake - button once.
E-STOP
User E-STOP triggered
push Brake to reset