B.
pO
wer
&
gr
Ound
w
iring
8
11. reMOve right dOOr sill triM
Repeat the previous three steps for the Right Side of the vehicle.
12. reMOve the rear seat BOttOM
Pull up firmly on the front of the edge of the rear seat bottom to
release. The back of the seat is attached by wire rod loops hooked
into down-ward facing tabs. Press down on the back edge of the
seat bottom and pull forward to release.
13. reMOve right cOwl panel
Open the Bonnet (aka the hood!). Remove the black plastic Cowl
covering the battery by releasing nuts (2) and (3) with a 10mm
socket. Remove the cowl.
NOTE: When replacing the cowl, be sure the seal (1) is seated
properly and that the secondary tab of the cowl (4) is inserted into
the plastic channel (5) that attaches to the bottom of the wind-
shield.
14. reMOve thru-wall cOver
Remove the battery.
Locate the thru-wall bushing behind the battery. Using a flat
screwdriver, release the indicated retaining tabs then remove the
plastic thru-wall cover to expose the thru-wall opening.
15. pOwer wire
Locate the Power Wire (with fuse holder) in the amp wiring kit.
REMOVE THE FUSE IF INSTALLED IN THE HOLDER! Feed the Red
Power Wire through the spare wiring nipple and into the cabin.
From inside the vehicle, locate the wire coming in. Feed the wire
around the fuse box and along the Right Door Sill.
Remove the auxiliary nut on the battery post with a 19mm socket
and attach the ring terminal on the end of the power wire.
see previOus iMages
