d.
sO
undst
age
15
44. reMOve dOOr speaKers
Remove the woofer mounting screws (1) with a Torx T-25. Unplug
the speaker connector (2). Repeat for the door midrange.
Keep the Torx screws - they will be used to mount the new speak-
er adapters.
45. reMOve arMrest cOver & triM
Remove Armrest Cover (1) by levering up the edges of the trim in
the directions indicated by the arrows.
Remove the trim cover (2) by releasing the two Torx-25 screws at
either end.
46. Midrange/MidwOOfer (Overview)
The Midrange/Midwoofer crossover network (1) installs in the cav-
ity behind the door armrest cover. The wiring harness connects
to the factory midrange connector (blue). The wiring harness is
routed behind the armrest trim and through the hole at the back
of the midrange cover to the factory connector and the midrange
driver. The wire for the woofer continues behind the midrange,
down and through the rubber grommet and on to the back of the
midwoofer.
47. Midrange/MidwOOfer wire harness
The wiring harness for the speaker and crossover connections to
the door speakers has been pre-fabricated. Connector (1) will plug
directly into the factory midrange connector. The 18” branch (3)
connects to the midrange driver. The 36” branch (4) connects to
the woofer. The stripped ends (2) connect to the crossover in the
armrest.
48. rOute & cOnnect wire harness
Route all wires through the opening (1) at the rear of the mid-
range cavity. Connect the blue connector to the factory midrange
connector. Leave the midrange wire in the midrange cavity. Con-
tinue running the woofer wire behind the midrange cavity, then
out and down to the rubber grommet (2). Using a utility knife, cut
a small slit in the grommet and run the woofer wire through and
into the door cavity. Be certain all wires are clear of any moving
parts or obstructions!
