c.
signal
w
iring
11
25. MOunt reMOte level cOntrOl
[SUB ONLY]
Connect the cable to the Remote Level Control. Mount the Re-
mote Level Control below the toggle switches. Wipe the surface
with the Alcohol Prep Pad before applying.
Do a dry-run to check the placement and be sure you know exact-
ly where you’d like the control. You will find that you can place
it more toward the front of the recess for easier access, or toward
the rear for a more hidden look.
26. cut & release Mid/MidwOOfer speaKer wires
[HIFI/HK ONLY] [HIFI/HK ONLY] [HIFI/HK ONLY] [HIFI/HK ONLY]
For HIFI/HK equipped vehicles ONLY!
Cut the Mid/Woofer Speaker wires at the X9331 T-Harness.
Remove the wires from the rest of the harness bundle UP TO
WITHIN 8 FEET OF THE RCAS at the other end of the harness.
These wires will be used later to connect to the factory wiring
downstream of the HIFI/HK amplifier.
27. reMOte turn-On wire
Identify the solid black wire coming out of pin 1 of the X15 con-
nector (from previous step). Locate the 18AWG White Remote
turn-on Lead wire in the signal harness. Unscrew both ends of
the Threadlock wiretap (the tap has a hole in only one end) Slip
the “U”-shaped bottom around the signal wire to be tapped. Care-
fully thread the body of the tap onto this and tighten firmly. Be
sure not to cross-thread the tap.
28. fish wiring tO BOOt
Beginning in the left (driver’s) side footwell, run the signal wiring
harness along the door sill, behind the left rear panel and to the
luggage compartment area by repeating the process you used to
fish the power/ground wires. Run the wires under the carpet trim
at the base of the rear seat backs, exiting at the right (passenger’s)
side of the luggage compartment. Be sure the wiring is clear of all
pinch points, including the Seat Belt screw.
29. aMplifier MOunting (Overview)
The amplifier bracket mounts against the side of the right rear
wheel well, with the flange on the long side of the bracket facing
down. The large hole in the upper left (towards the front of the
vehicle) slides over the lower threaded stud at the front the wheel
well area. The rear hole in the bottom flange aligns with the hole
in the sheet metal below.
[sub ONLY]
[hifi/hk ONLY]
