d.
sO
undst
agae
16
49. crOssOver cOnnectiOns
Connect the stripped wires ends to the crossover board. The
branch from the blue connector connects to the “IN”. The mid-
range branch connects to “M”, and the woofer branch connects to
“W”. Red is + and Black is - for all three.
[NOTE: Xover board shown with foam cover removed for clarity]
50. MOunt Midrange & MidwOOfer
Mount the Woofer Adapter to the door with the factory Torx
screws removed earlier. Connect the woofer wiring, making sure
the connectors lock to the speaker tabs. Use wire ties to ensure
that the woofer wiring is clear of the window mechanism! Mount
the woofer with the #8 x 1/2” black oxide screws.
Repeat the process for the Midrange, using the #6 x 3/8” screws.
51. tweeter installatiOn (Overview)
The Soundstage Tweeters install directly into the factory tweeter
mounts on the A-Pillar trim (the trim at either side of the wind-
shield). The tweeter crossover networks install in a small com-
partment on either side of the dashboard. The crossover input
connects to the tweeter wire from the amp and the 18” tweeter
pigtail connects to crossover to the tweeter.
[6SPK ONLY] The new A-pillar trim is included
52. reMOve a-pillar triM
Carefully lever/pry out screw cap cover (1). Remove the T-20 Torx
screw underneath. Loosen the door seal (4) to gain access to the
edge of the trim piece (3). Pull inward to release clips (2). Discon-
nect the tweeter wire and remove the the trim piece.
[6SPK ONLY] You will not be reusing this trim piece
[HIFI/HK ONLY] You WILL be reusing this trim piece.
53. reMOve existing tweeter
[HIFI/HK ONLY]
Release tabs (1) and remove tweeter (2). Unclip capacitor and wire
(3) and remove.
[hifi/hk ONLY]
