9
21. SWAP ASD WIRING HARNESS HOUSING (PART 1)
Remove the inner connectors from the gray housing by prying
open the latch where indicated (each side) and sliding the inner
connectors out.
22. SWAP ASD WIRING HARNESS HOUSING (PART 2)
Insert the gray and black inner connectors from the last step into
the black outer housing included in the Soundstage kit. The inner
connectors are keyed and will only insert one way into the outer
housing.
23. PLUG ASD WIRING INTO SIGNAL HARNESS
Connect the ASD wiring with the new black housing to the black
housing (1) shown.
24. ROUTE SIGNAL WIRING INTO CENTER TRUNK COMPARTMENT
Route the Signal Wiring Harness along the bottom of the factory
amplifier compartment to the rear of the compartment, then up
over the beam running lengthwise, then to the center trunk com-
partment. Shown with panels reinstalled for clarity as to finished
routing. The dotted red line is the harness behind the panels.
25. HARDWARE SELECTION
Locate the
Power Wiring Harness [F3X.WH.PWR]
.
REMOVE THE FUSE FROM THE FUSE HOLDER, IF INSTALLED.
[Old version of harness shown]
B.
AMPLIFIER & SIGNAL WIRING
