C.
SOUNDST
AGE
14
46. INSTALL THE IASS-8S WOOFERS IN THE USW ENCLOSURE
Use the four
#6 x 1.25” Pan Head Screws
to mount the woofer to
the enclosure (these are the longer, thinner screws with a round-
ed head - don’t confuse them with the cover screws which are a
little thicker and shorter and have a flat head).
47. RE-INSTALL THE USW ENCLOSURE
Re-install the enclosure in the vehicle. It may take a little wig-
gling to get the open end (the side towards the door sill) to slide
into its slot. Make sure all wiring is run clear. Replace the two
nuts removed previously and tighten with a 10mm socket.
Connect the USW plug to the factory connector. Replace the car-
pet.
48. HARDWARE SELECTION
Select the remaining items from the
Underseat Woofer Hardware
Kit:
the eight
Nylon Spacers
and the eight
#8 x 1” Flat Head Screws
.
49. INSTALL THE USW COVER GRILLE (STEP 1)
Place the spacers over the screw bosses as shown.
(enclosure shown removed for clarity)
50. INSTALL THE USW COVER GRILLE (STEP 2)
The raised “feet” on the cover grille fit over the spacers and
should lock into place. Attach the cover with the four
#8 x 1” flat
head screws
. Put the seat back in place, but do not re-bolt it yet!
(enlclosure shown removed for clarity)
REPEAT THE PREVIOUS 8 STEPS FOR THE OTHER SIDE
