Integra DTR-70.3, Инструкция по эксплуатации

Страница: 79 / 108

79
En
You’ll need to enter a code for each component that you
want to control.
Note
• Though the provided remote control codes are correct at the time
of printing, they are subject to change.
12 When you searched for the model, a message
“Successful” will appear. Now the transfer is
successful!
Go to step 15.
When you did NOT search for the model, push any
key (except for arrow buttons and
Enter
) to see if
the component responds.
Tip
• The numbers in [ / ] mean the order of the candidate code
and the total number of codes for the brand.
13 If you can control component, press Receiver , use
q / w to select “Works”, and then press Enter .
If you cannot control component, press Receiver ,
use
q
/
w
to select “Doesn’t work (Retry)” and press
Enter
.
The next code appears. Repeat from step 11.
14
Press Enter to transfer the determined code.
15
Press Enter .
You’ll return to the category selection menu. Press
Setup
to end the remote mode setup.
15
15
Input sensor
Transmitter
15° off center
(Left/Right/Up/Down)
Approx.
16 ft. (5 m)
Entering Remote Control Codes
1
Look up the appropriate remote control code in the
separate Remote Control Codes list.
The codes are organized by category (e.g., DVD
player, TV, etc.).
2
While holding down the Remote Mode to which
you want to assign a code, press and hold down
Display (about 3 seconds).
The Remote Mode button lights.
Note
• Remote control codes cannot be entered for
Receiver
and
Zone .
• Only TV remote control codes can be entered for TV .
• Except for
Receiver
,
TV
and
Zone
, remote control codes
from any category can be assigned to the Remote Mode .
However, these buttons also work as input selector buttons
(
➔
page 23
), so choose a
Remote Mode
that
corresponds with the input to which you connect your
component. For example, if you connect your CD player to
the CD input, choose
TV/CD
when entering its remote
control code.
3
Within 30 seconds, use the number buttons to enter
the 5-digit remote control code.
Remote Mode button flashes twice.
If the remote control code is not entered successfully,
Remote Mode button will flash once slowly.