Integra DTR-30.7, Руководство пользователя

Страница: 19 / 32

Step 3: Playing Back
En-19
6
Multi-zone
You can listen to audio in a room (called Zone 2) other than
the one where this unit is located (called the main room).

Sources you can playback
● External players (

1)
● NET (

2)
● Bluetooth
● AM/FM Radio

1 Only analog and 2ch PCM audio signals can be output to Zone 2.

2 DSD and Dolby TrueHD audio signals cannot be output to Zone 2.
Important : Connection with external players
To listen to a player in Zone 2, you must connect using an
RCA cable, a digital optical cable (OPTICAL), or a digital
coaxial cable (COAXIAL). Some players may require audio
output setting.
AUDIO
OUT
DIGITAL
OPTICAL
OUT
Making Multi-zone Connection
There are the following two methods of connection:
a. Connecting with a pre-main amplifier or a power amplifier
in a separate room
b. Connecting with speakers in a separate room

a� Connecting with a pre-main amplifier in a
separate room
It is possible to play 2 ch source in a separate room while
7.1 ch source is being played in the main room.
Connect the PRE/LINE OUT ZONE2 jacks of the unit and
the line-in jacks of the pre-main amplifier in a separate
room with an RCA cable.
Main room
Zone 2
● Settings are required in order to control volume and
sound quality on this unit. To adjust it with the unit, press
Receiver
and then Setup on the remote controller,
select "3 Audio Adjust" - "Multi Zone" - "Zone 2 Out"
and set the setting to "Variable". If you connect a power
amplifier, be sure to make the setting and adjust the
volume on this unit.

b� Connecting with speakers in a separate
room
Connect the speakers in another room to the SPEAKERS
ZONE2 jacks of the unit using speaker cables. Note that
5.1 ch will be the maximum (

) in the main room during
Zone 2 playback. No sound will be output from the back
speakers and height speakers.
¼ 
In this case, the Dolby Atmos listening mode cannot be selected.
Main room
Zone 2
These settings are required : After connecting
the speakers, press Receiver and then Setup
on the remote controller, select "2. Speaker" -
"Configuration" and set "Powered Zone2" to "Yes".
DTR-30.7_BAS_En_SN29401993_150414.indd 19 2015/05/14 16:32:54