Integra DHC-80.2, Инструкция по эксплуатации

Страница: 83 / 116

83
En
■
Zone 2 Power On Volume,
Zone 3 Power On Volume
`
Last , Min , 1 to 99 or Max (Absolute display)
`
Last , –
Q
dB , –81dB to +18dB (Relative display)
This setting determines what the volume will be for
Zone 2/3 each time the AV controller is turned on.
To use the same volume level as when the AV controller
was last turned off, select “
Last ”.
The “ Zone 2 Power On Volume ” and “ Zone 3 Power On
Volume ” cannot be set higher than the “ Zone 2 Maxi-
mum Volume ” and “ Zone 3 Maximum Volume ” setting.
■
Zone 2 Component Out
`
Use :
Select if a TV in Zone 2 is connected the COMPO-
NENT VIDEO ZONE 2 OUT .
`
Not Use :
Select if no TV in Zone 2 is connected the
COMPO-
NENT VIDEO ZONE 2 OUT
.
If you’ve connected the COMPONENT VIDEO ZONE 2
OUT to a TV in Zone 2, this setting is set to “ Use ”.
Note
If the “ Zone 2 Component Out ” setting is set to “ Not
Use ”, the same video signal as COMPONENT VIDEO
MONITOR OUT is output from ZONE 2 OUT (compo-
nent).
This section explains how to turn Zone 2/3 on and off,
how to select an input source for Zone 2/3, and how to
adjust the volume for Zone 2/3.
Controlling Zone 2/3 from the AV Controller
Note
• When Zone 2/3 is turned off, the output from the 12V TRIG-
GER OUT goes low (0 volts).
Using Zone 2/3
1
To turn on Zone 2/3 and select an input source,
press
Zone 2 or Zone 3 followed by an input
selector button within 8 seconds.
Zone 2/3 turns on, the Zone 2/3 indicator lights.
Tip
• The 12V TRIGGER OUT goes high (+12 V).
To select AM or FM, press Tuner input selector and
Zone 2 or Zone 3 repeatedly.
(North American models) You can also select SIR-
IUS.
To select the same source as that of the main room,
press
Zone 2
or
Zone 3
twice. “ Zone2 Selector:
Source ” or “ Zone3 Selector: Source ” appears on
the display.
2
To turn off Zone 2/3, press Off for each Zone.
The zone is turned off, and the
Zone 2
or
Zone 3
indicator goes off.
Zone 3
Zone 2
Off
Zone 2 indicator
Input selector buttons
Zone 3 indicator