Customer Services (858) 578-7887 & (888) GO IN
TEC
IN
TEC
Controls, 12700 Stowe Dr., Suite 1
0
0, Poway, CA 92064
Fax (858) 578-4633 & (888) FX IN
TEC
www.inteccontrols.com
Specification subject to change without notice.
Printed in USA 130917
Polygard® is a registered trademark of MSR
DGC3
PolyGard
®
Digital Gas Controller
User Manual - DGC3
Page 17
3.6.7 Control Mode
Definition of the alarm evaluation by means of current (CV) or average value (AV).
Symbol Description
Default
Status t Function
MP 01
Measuring Point
Selection of MP No.
CV Evaluation CV CV = Control by the current gas value
AV = Control by the average gas value
Current- average value function see: 3.7.4
3.6.8 MP Fault Assigned to Alarm
Definition, which alarms are activated in case of a fault at the measuring point.
Symbol Description
Default
Status
Function
MP 01
Measuring Point
Selection of MP No.
Alarm - 1 2 3 4
Fault - 1 1 0 0
Fault MP
1 1 0 0
0 = Alarm not set at MP fault
1 = Alarm set at MP fault
3.6.9 Alarm Assigned to Alarm Relay
Each of the 4 alarms can be assigned to any alarm relay. Unused alarms are not assigned to any alarm relay.
Symbol Description
Default
Status
Function
MP 01
Measuring Point
Selection of MP No.
1
A1
A2
A3
A4
01
02
03
00
01 = Alarm 1 activates alarm relay R 01
02 = Alarm 2 activates alarm relay R 02
03 = Alarm 3 activates alarm relay R 03
04 = Alarm 4 doesn’t activate any alarm relay
3.6.10 MP Signal Assigned to Analog Output
The measuring point signal can be assigned to the analog output. At this the signal defined in the control mode
(current or average value) is transmitted.
Analog output see also: 3.7.2
Symbol Description
Default
Status
Function
MP 01
Measuring Point
Selection of MP No.
0 A
0 0 = MP Signal not assigned to analog output
1 = MP Signal assigned to analog output 1
Specifications subject to change without notice. | USA 130917 | Page 17 of 22
12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.IN
TEC
| relevantsolutions.com/inteccontrols
DGC3 – UserManual
Polygard® is a registered trademark of MSR | DGC3
Specifications subject to change without notice. | USA 160104 | Page 17 of 22
12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.IN
TEC
| relevantsolutions.com/inteccontrols
DGC3 – UserManual
PolyGard
®
is a registered trademark of MSR-Electronic GmbH | DGC3
INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com
Specifications subject to change without notice. | USA 200211 | Page 17 of 22
DGC3 – UserManual
