Inta Nulo CB10031CP, Инструкция по установке и обслуживанию

Страница: 13 / 20

© Intatec Ltd 2017
12
Installing the Riser Rail
The screws and wall plugs supplied are only suitable for use in solid walls. If the wall is plaster
board or soft building block use special wall plugs obtainable from most DIY stores.
Ensure there are no supply pipes or cables where you intend to drill.
Where possible, drill holes between ceramic tiles (in the grout). If drilling into ceramic tiles use
a ceramic bit.
This product must always be used and fitted in such a way as not to cause water damage,
therefore should be located and directed towards a suitable shower tray.
Take care to use power tools safely.
Take the wall bracket for the bottom of the riser rail, mark the position of the hole on the wall and
drill the hole.
To avoid cracking ensure the wall plug is pushed all the way behind the ceramic tile.
Using the screw provided secure the wall bracket (1) to the wall ensuring the correct orientation
for the bracket.
Assemble the handset holder onto the riser rail as shown.
Insert the riser rail end caps (2) into the riser rail (3) and push fully into the rail.
Offer the riser rail to the bottom wall bracket and hold in position, using the fixings provided
(bolt and nut - 8)
Assemble the upper wall bracket to the riser rail, position on the wall with the riser rail vertical
and mark the location using a removable marker.
Remove the rail.
Drill the hole for the upper bracket and secure the bracket to the wall using the screw and rawl
plug provided.
Assemble the riser rail to the two wall brackets and secure in position using the two bolts and
nuts (8).
Ensure the ½”sealing washers are inserted into both ends of the flexible hose (7) and connect the
hose to the shower valve and the handset (6).
Turn on the shower valve and check joints for leakage.