INSYS GSM 4.2 easy, Дополнительное руководство

Страница: 23 / 39

8. Disconnect the power supply.
9. Press the sunken yellow button (see image) above the
SIM card slot and remove the cardholder. Put the SIM
card into the cardholder and reinsert it. The contacts of
the SIM card face to the left when inserting.
10. Connect the power supply.
11. The initialization process restarts (see point 4): If the
device has logged in successfully, the LEDs
Power and
Status are on afterwards and the LED Signal indicates
the strength of the GSM signal.
12.
Check the field strength of the GSM signal using the
button
Detect GSM field strength.
The response should be a field strength of at least 12 – otherwise, the antenna
location needs to be changed.
4.3 Troubleshooting
4.3.1 No response on commands
The INSYS GSM 4.2 easy and the terminal device (configuration PC or con-
troller) have to operate the serial interface with the same baud rate and
the same data format (Default:
19200
bps,
8N1
).
The INSYS GSM 4.2 easy can be reset to the factory settings by pressing the
Reset key for an extended period (> 25 seconds).
4.3.2 No connection established
Check the signal quality of the GSM network.
Has the INSYS GSM 4.2 easy been logged in?
Has the SIM card been enabled for incoming data connections?
Was the phone number for the data connection dialled?
Is the power supply during sending sufficient?
4.3.3 Alarm SMS is not dispatched.
Has the SMS service center number been entered correctly?
Has the SMS destination number been entered correctly?