Instruction Manual IGM402 Hornet
InstruTech
Page 22
5.7
Factory-Set Default Parameters
The following is a summary of all
factory-set default
values in the IGM402 Top Level Program Menu.
SETUP DISP
- SET CONTRAST [Factory default =
10
]
- SHOW DATA [Factory default =
SHOW ALL LG
]
- DISPLAY INT [Factory default =
3 SECONDS
]
- FLIP SCREEN [Factory default =
NORMAL
]
- SCREEN SAVER [Factory default =
ON
]
SETUP UNIT
- UNITS [Factory default =
TORR
]
- DEFAULTS [Factory default =
MENU TO EXIT
]
-
CLR IG ERROR [Factory default =
OFF
]
- 100UA TRN ON [Factory default =
5.00E-02 TORR
]
- IG CNTL [Factory default =
DIGI/RS485,
(Factory default is
DIGI
or Digital Input, see requirement for
switching from
DIGI
to
RS485
mode at the
DIGI/RS485
section
, below)]
If IG CNTL is set to
FRONT PANEL,
the Top Level Program Menu shown here will be modified; See
section 5.8.2.,
-FRONT PANEL
,
for the
modified Top-Level Program Menu choices when IG CNTL is set for
FRONT PANEL.
SETUP IG
- DEGAS TIME [Factory default =
2]
- SENSITIVITY [Factory default =
Actual Sensor sensitivity (see label on gauge)
]
- FILAMENT NUM [Factory default =
FILAMENT 1
]
- RLY I LO TRP [Factory default =
1.00E-06 TORR
]
- RLY I HI TRP [Factory default =
5.00E-06 TORR
]
- RELAY I TEST [Factory default =
OFF
]
- ANALOG MODE [Factory default =
IG ONLY
]
- FIL USAGE [Factory default = Displays to-date filament usage]
SETUP CGS
- RLY A LO TRP [Factory default =
1.00E-1 TORR
]
- RLY A HI TRP [Factory default =
2.00E-1 TORR
]
- RELAY A TEST [Factory default =
OFF
]
- RLY B LO TRP [Factory default =
1.00E-1 TORR
]
-
RLY B HI TRP [Factory default =
2.00E-1 TORR
]
- RELAY B TEST [Factory default =
OFF
]
- ASSIGN RLY A [Factory default =
CG1
]
- ASSIGN RLY B [Factory default =
CG2
]
