Instrumentation GDD GRx8mini, Инструкция по эксплуатации

Страница: 91 / 141

Instrumentation GDD Inc. 2018-04-06 Page 91
Verify that the power supply is working properly: unplug the power supply from the
receiver and from its power source. Plug it into the power source again and the green light
should turn on.
Problem:
The message: ‘GDD Rx – No Receiver’ is shown in the program bar of the GDD Rx program. It
stays on the bar even if the Allegro
2
is connected to the receiver.
Answer:
Check that the receiver’s On-Off switch is at On and that the LED is on.
Verify that the receiver’s batteries are powered enough and not within the critical threshold
limit.
In Cable mode, verify that the cable is plugged correctly into the receiver and into the
Allegro
2
field PC. If you are using the D-SUB 9 to D-SUB 9 cable, try replacing the cable to a
D-SUB 9 to Amphenol 6 cable (or the opposite if you were using a D-SUB 9 to Amphenol 6 as
your primary cable).
In Cable mode, make sure your cable is connected to the COM1 port of the Allegro
2
field PC.
In Bluetooth mode, this can happen if the Bluetooth module of the field PC did not close its
virtual communication port properly. Close the GDD Rx program and turn off the receiver.
Wait for about 10 seconds and then, turn on the receiver and try to restart the GDD Rx
program in Bluetooth mode.
If the program still not detects the receiver in Bluetooth mode, open the program in RS232
mode and save all your data. When your data is saved, push and hold the ON button of the
Allegro to reset it.
Problem:
In Bluetooth mode, the following message appears.