SwitchLinc Timer Owner’s Manual
Page 19 of 23
COLOR OPTIONS FOR SWITCHLINC TIMER
You can change the color of the SwitchLinc paddle trim frame to match the décor of any room with an
optional paddle color change kit. Color options include light almond (#2400LAL), almond (#2400AL),
black (#2400BK), brown (#2400BR), gray (#2400GY), ivory (#2400IV), light almond (#2400LAL), or white
(#2400WH). Each paddle color change kit includes two paddles.
LED color change kits are also available in blue (#2400LBL), red (#2400LR), frosted white (#2400LF), or
a 4-color (amber, blue, green, and red) pack (#2400L). Each LED color change kit includes eight pairs of
light pipes.
Color change kits are available at:
www.smarthome.com
Changing the Paddle and LED Colors
You can remove the front paddle and trim frame assembly before or after SwitchLinc is installed. During
the changeover process, the power and the load may remain on and operating. There are no dangerous
voltages or unsafe areas under the paddle.
This section is also available as a tutorial video. See
www.smarthome.com/productvideos.html
1)
If SwitchLinc is already installed in the wall, remove the wallplate from the switch junction box
2)
Remove the screws that hold the paddle assembly to the metal frame
3)
Pull the entire frame straight away from the switch. You may have to
wiggle the bottom of the frame to get it free from the Set button
4)
Using a flat blade or needle nose pliers, remove the large light pipe. The
light pipe will snap out of the frame. Do the same for the small light pipe.
5)
Choose which LEDs and/or paddle and trim frame you would like to install into SwitchLinc
6)
Orient the new small light pipe with its protrusion facing
toward the center of the new frame and snap it into place. If
placed backwards or reversed, it will not click into place.
7)
Orient the new large light pipe with the side that has the most
protrusions facing toward the center of the new frame. Using
only finger pressure, snap the light pipe into the frame.
