Assembly (continued)
7
(4)
(5)
(6)
Step 30
Step 31
Step 32
COVERING THE SPA
32. Unwrap the Spa Cover (7) and open it out on the floor.
33. Open the self-inflating valve (located on the inside of the cover). This will allow
air into the cover and, over time, smooth out wrinkles.
34. Inflate the Spa Cover (7) with the pump.
IMPORTANT - After being inflated for between 15-30 minutes, the wrinkles on
the cover should have smoothed out. At this time close the self-inflating valve.
If the valve is not closed, then air from the the spa jets will blow into the cover.
35. When the spa is full, cover it making sure that the skirt of the cover is pulled
completely down around the top tube. Make sure the self-inflating valve (see
previous Step) is closed before covering the Spa. The cover may appear slightly
wrinkled at first, but will become smooth when the water gets warm.
LOCKING THE SPA
36. The spa can be protected by lockiong it after each use. When the cover is on,
4 sets of straps around the Spa will hang down from the cover. Each set has a
long strap and a short strap, each with a D-ring attached to it.
37. Pull down the Outer Skirt and expose the Aluminum Frame. Tuck the long strap
behind the aluminum frame and bring it back out. Repeat this for each set of
straps.
38. Attach your own locks or other locking devices to both D-Rings in each set of
straps to lock the Spa Cover down.
Step 33
Step 34
Step 35
Step 36
Step 37
Step 38
WRAP THE INSULATION AROUND THE FILTER
30. Take the filter insulation (4), (5), & (6). Join all 3 pieces together
by matching the velcro connectors.
31. Wrap the insulation around the filter and tuck it in.
Make sure that the “DO NOT SIT” Warning is on top.
Step 29
Step 28c
Step 28d
28c. Wrap the Vinyl Outer Skirt (2) tightly around the Aluminum Frame of the
Spa by pulling tightly on the skirt. As you pull tightly, walk the Skirt around
the Spa letting the Skirt slide through your hands as you pull. The Skirt
must be as tight as possible against the aluminum frame, just under the
inflated top ring.
28d. Move completely around the Spa, pulling the skirt and keeping it tight
against the Aluminum Frame.
29. When you get to the end, pull the two ends together and secure it with the
Velcro pads. If the two ends of the skirt do not meet, Re-wrap it around the
Spa, pulling tighter and making sure it is pressed in as tight as possible to
the aluminum frame. The skirt must be tight for maximum insulation.
Walk around the Spa and check the positioning of the Vinyl Outer Skirt (2).
Adjust it so that the bottom is flat on the floor and the top fits snugly under
the Inflated Top Ring.
COVER THE ALUMINUM FRAME WITH VINYL OUTER SKIRT (continued)
InstaSPA
™
InstaSPA
™
InstaSPA
™
