BUILD THE ALUMINUM FRAME (continued)
9. Connect all the tubes together until you have almost formed a circle
10. Connect the last two curved pieces together to complete a circular frame.
The finished frame should have a blue bottom ring and a silver top ring.
The top ring is smaller than the bottom ring.
INSERT THE SPA INNER LINING
11. Open the Spa Inner Liner (1). If it is cold outside, this process is best accomplished
inside when the lining is warm and supple.
12. Remove the protective Packing from the Intake and Return Valves and tubing
attached to the Inner Lining.
Silver top ring.
Blue bottom ring.
Assembly (continued)
Step 12
Step 11
Step 10
Step 9
5
CONNECT THE FILTER TO THE INNER LINING
13a. & 13b. Attach the Filter (8) to the Inner Liner (1).
Before connecting all the hoses or pipes, make sure that there is a rubber washer
on the end of each. If a Connecting Pipe (9) does not have a rubber washer on
the end, look for it in the package and put it on the end.
a) Important: Place the hoses that are attached to the filter so that one is above
and one is below the 2 jet hoses that are attached around the Inner Lining.
b) Tighten the threaded collars hand tight, then use the plastic wrench to tighten
them firmly, but do NOT over-tighten. These hoses contain water when operating.
14. Connect the Connecting Pipes (9) to the 2 Jet Hoses that are attached to the Inner
Lining.
15. Tighten the threaded collars hand tight, then use the plastic wrench to tighten
them firmly, but do NOT over-tighten. These hoses will contain water when
operating.
16. Put the Inner Lining inside the Aluminum Frame. Pull the Filter and Connecting
Hoses through the frame.
Step 15
Step 13b
Step 16
17. Take the Hand Pump (3) and begin to pump up the Top Ring on the Inner Lining
via the connector located on the underside of the Top Ring. As the Top Ring
becomes inflated lift it so that it sits completely on the top of the Aluminum
Frame. Inflate the Top Ring just enough that it can sit on top of the Aluminum
Frame. Do NOT fully inflate it. MAKE SURE THAT THE FRAME IS THE CORRECT
WAY UP. The silver (smaller) circular frame must be on top and the blue (larger)
frame must be on the bottom.
18. Before the top ring is fully inflated, slide the intake cover (13) down the retaining
rails. There is only one way it will slide on, so if you have trouble, turn the intake
cover over and try again.
19. Finish inflating the top ring so that it is hard to the touch, then center it on top
of the aluminum frame. Disconnect the Hand Pump hose and close the Retaining
Cap.
Step 17
Step 18
Step 19
Step 13a
Step 14
(9)
(8)
InstaSPA
™
InstaSPA
™
InstaSPA
™
