8
SAFETY TESTING OF CIRCUIT BREAKERS FOR FIRST TIME USE
Always conduct the following electrical grounding safety tests before using the spa
the first time or after it has been disconnected for a period of time.
40. GFCI test procedures:
The InstaSPA cord is fitted with a ground Fault Circuit Interrupter (GFCI), a very
important safety feature. The GFCI shuts off the electricity in a fraction of a second
if there is a short in the cord or the motor unit. This plug fits conventional 120v
(USA) outlets found in most homes. It is recommended that the GFCI be tested prior
to each use.
(A) Push the Test button on the GFCI. The light on the GFCI and the light(s) on the
control panel should go out. If any of the lights fail to got out, DO NOT USE THE
SPA. UNPLUG THE UNIT AND CALL CUSTOMER SERVICE.
(B) If the GFCI tests are okay, firmly push the RESET button back into place and the
motor unit should resume power. IF RESET button fails to reset properly, or if
power does not return to the motor unit, DO NOT USE THE SPA. UNPLUG THE
UNIT AND CALL CUSTOMER SERVICE.
(C) If the GFCI trips by itself at any time, firmly press the RESET button back into
place and perform the above tests. If this happens more than once, UNPLUG THE
UNIT AND CALL YOUR CUSTOMER SERVICE.
Operational Instructions
CONNECTING THE InstaSPA to POWER
39. After the InstaSPA is full of water, unwrap the power cord from inside the
motor housing compartment. Plug the cord into a standard power outlet.
- Connect to a grounded outlet only.
- Do not use an extension cord unless you contact a certified electrician to
determine the specifications of extension cords that can be used with the
InstaSPA in your country.
- Do not touch the power cord, the motor, or the controller when your hands
are wet.
- Do not plug in the motor while filling or draining.
BEFORE OPERATING, YOU MUST ENSURE THAT ALL NECESSARY SAFETY
INSTRUCTIONS AND CAUTIONS ARE FOLLOWED.
Step 40
Step 39
Starting InstaSpa for the 1st Time, or after it has been drained
and then refilled. Clear air from system.
Fill the Spa with water, then plug it in to a grounded 110-120v outlet. Contact a
qualified electrician if you cannot verify that the outlet is grounded.
Press Reset Button
Any time you plug in the Spa, or restart it after it looses power, you must press the
reset button.
• Locate the Reset Button behind the door in the motor housing.
• Push ON/OFF Power button (1), then immediately press the Jet Button (4).
• Allow the Motor to start and the Jets to Kick in.
• After Jets start, push the Jets button again to switch Jets off.
(This procedure will force all air out of the pipes and motor).
• Set the Target temperature to your desired target temperature.
Wait for 24 hours for Spa to warm up.
• Cover the Spa. Lock the Spa Cover.
InstaSPA
™
InstaSPA
™
InstaSPA
™
