9
SPA CONTROLS AND OPERATION
BEFORE OPERATING, YOU MUST ENSURE THAT ALL NECESSARY
SAFETY INSTRUCTIONS AND CAUTIONS ARE FOLLOWED.
Power On/Off Button
When in normal use, leave the Power on all the time. Use the
Temperature Controls to set the target temperature for the Spa.
When you press the Power button, the red indicator light and
the red Temperature lights will come on and your Spa is ready
to operate.
IMPORTANT Starting and Re-Starting InstaSPA
Reset Button
Any time you plug in the Spa, or restart it after it looses power, you
must press the reset button. Located in the door in the motor
housing.
Power Connection Indicator
When the Spa is plugged into the power socket, the green
power indicator light will be on. This indicates that power is
reaching the Spa.
Warning Tone
Always disconnect the spa from the electrical-power socket if you
intend to leave the power turned off. If you turn the Spa Power Off
and leave it plugged into the electrical socket, a warning “beeping”
sound will alert you to unplug the spa when it is switched off. This
warning sound will NOT occur when you first plug the spa into the
electrical socket when it has not been in use. If Spa is plugged in
but the indicator light is off, check the GFCI (USA) or Residual
Current Circuit Breakers (International). See page 8.
Water Temperature
Temperature Increase / Decrease buttons
Push the Up or Down Temperature Control Arrows to set to desired
“Target” temperature. The thermostat will automatically turn the
Spa Heater on if the actual water temperature is less than the Target
temperature. When desired water temperature is reached, the Spa
Heater will automatically turn off.
For maximum heating rate, always close the air-control valve
when Spa is not being used (See Air Control below).
Water Jets
Jets button
Use the Jets button to control the power of the water jets when
using the spa.
Always remove the Spa cover before using the
jets.
When the jets are turned on, a 15-minute timer is activated.
The Jets will automatically shut off after this 15-minute period. If
you want the jets to stop within that period, press the jets button
again. When the jets are on, power is diverted from the main heater
and only the auxiliary heater operates. Water temperature tends
to fall slightly while the jets are on. When the jets are switched off,
the main heater will switch on automatically if the water temperature
has fallen below the target temperature.
Air Control
The Air Control Knob
The air control valve adds air bubbles into the spa. To open the air
control, rotate the knob counter-clock-wise one quarter of a turn.
To close the air control, rotate the knob clockwise. Air bubbling
through the Spa water gradually lowers the water temperature, so
always turn the air-control valve OFF for maximum heating
rate when the spa is not being used.
Jet Head Control
Each jet can be individually directed by rotating the head of the
jet manually.
Operational Instructions
1
InstaSPA
™
InstaSPA
™
InstaSPA
™
2
1
2
3
4
3
5
4
3
5
