Instanta InstaTap I2CB10, Инструкция по установке и эксплуатации

Страница: 27 / 40

27
Installation instructions & user guide
T210042 v1.00 March 2022 - InstaTap Commercial
NOT
READY
o
C
HEATING
NOT
READY
o
C
HEATING
70
o
C
SOFT MEDIUM HARD
CHANGE FILTER
Pr
READY
o
C
96
CAUTION
HOT WATER
NOT
READY
o
C
96
CHECK
WATER
! !
CHANGE FILTER
NOT
READY
OF
! !
READY
CHECK
WATER
! !
READY
! !
CLEAN
PROBES
READY
MEDIUM
! !
NOT
READY
o
C
!
CHECK
WATER
READY
o
C
96
CAUTION
HOT WATER
• When the programmed temperature has been
reached, READY, CAUTION HOT WATER, (TEMP)
O
C
is displayed.
• The red background illumination is extinguished.
• The tap controls illuminate.
NOT
READY
o
C
HEATING
NOT
READY
o
C
HEATING
70
o
C
SOFT MEDIUM HARD
CHANGE FILTER
Pr
READY
o
C
96
CAUTION
HOT WATER
NOT
READY
o
C
96
CHECK
WATER
! !
CHANGE FILTER
NOT
READY
OF
! !
READY
CHECK
WATER
! !
READY
! !
CLEAN
PROBES
READY
MEDIUM
! !
NOT
READY
o
C
!
CHECK
WATER
READY
o
C
96
CAUTION
HOT WATER
• If the tank does not fill to its pre-set level within :
I2CB40 & I2CB50 models : 10 minutes.
All other models: 6 minutes.
• CHECK WATER is displayed.
• If this happens, check that the isolation valve is
turned on, there are no kinks in the inlet hose and
that the Water Block doesn’t need to be reset.
• If these are in order, check that the filters in the
Water Block and water connection point are not
clogged with debris.
• To clear the warning, switch off the UCB mains
electricity supply, and then switch back on.
• When the water level reaches the boiler’s bottom
sensor, the heater is switched on.
• NOT READY, HEATING, -- O C is displayed.
• When the water temp is close to the programmed
temperature , the real time temperature is
displayed.
NOT
READY
o
C
HEATING
NOT
READY
o
C
HEATING
70
o
C
SOFT MEDIUM HARD
CHANGE FILTER
Pr
READY
o
C
96
CAUTION
HOT WATER
NOT
READY
o
C
96
CHECK
WATER
! !
CHANGE FILTER
NOT
READY
OF
! !
READY
CHECK
WATER
! !
READY
! !
CLEAN
PROBES
READY
MEDIUM
! !
NOT
READY
o
C
!
CHECK
WATER
READY
o
C
96
CAUTION
HOT WATER
• The UCB does not fill completely at once. The water input is electronically
controlled to obtain maximum output, temperature and efficiency.
• Dispense (see page 31) 3 litres of water to flush the UCB system.
• Wait again for the screen to read READY before making a drink.
IMPORTANT NOTE In daily use you may use the appliance as soon as the
tap controls illuminate but on first installation wait at least 10 minutes
before starting to use the water.
SECTION 7 Commissioning