4. Press the Up or Down arrows located to the right of the viewscreen to tab the
selection to Off.
5. Press the OK button (top-left button on the back of the camera) to Confirm
your selection.
6. The camera can either be turned off with the Power button on the right side of
the camera (button with open circle with a line through the center) or can
escape out of Menu mode, pressing the Menu/Back button, to begin auto-
recording using the new ADAS settings turned Off.
NOTE:
Screen alerts and beeps will not occur, however if an EVENT is
triggered due to the G-Sensor settings, the screen will light up with an
[EMERGENCY] text to notify the driver.
3. How do I adjust the viewscreen Backlight (LCD) settings? The screen
stays on [too long/too short].
Answer:
Some drivers find the Backlight settings distracting, particularly while
driving long distances at night. Due to the nature of the dash camera in relation
to possible Events, there is no full way to turn the screen off while driving. If
needed, however, you may reduce the amount of time the screen backlight is on
by going into the settings. By default, the screen is set to turn off after 30
seconds. The backlight setting doesn't affect recording – the dash camera will
continue to record in the background with the screen off. You can quickly check
to see if the camera is recording by locating the middle, blue LED light on the
back-left of the camera. If this blue LED is blinking on and off, the camera is
recording regularly.
Troubleshoot:
1. Press the Menu/Back (bottom-left) button on the back of the camera. Doing
so will stop the camera recording and show the Menu (P 1/5).
2. Press the Up or Down arrows located to the right of the viewscreen to tab to
Menu (P 2/5) until “LCD Setting” is highlighted.
3. Press the OK button (top-left button on the back of the camera) to Confirm
your selection.
4. By default, the backlight is set for 30 seconds and will turn off. Use the Guide
below to figure out what setting works best:
1.
Backlight stays on too long
: Press the Up or Down arrows located to the
right of the viewscreen to change the LCD Setting to “Off” to turn the
screen off after a few seconds or keep at “Turn Off After 30 Sec.”
2. Backlight doesn't stay on long enough:
Press the Up or Down arrows
amiGO! Dash Cam DC711 FAQ Version 1.2 (03/22/19)
Page 19
