11
Inspire Home Automation
www.insiprehomeautomation.co.uk
Installation & User manual
Wiring your Inspire Thermostat
Your new Thermostat is a two wire Thermostat. It requires only the Live (L) and the
Switched Live (SL) wire. It does not matter which wire is connected to which terminal.
Note:
Great care must be taken to ensure that your room thermostat is wired correctly. Incorrect
wiring can be dangerous and could result in a blown fuse and / or a damaged room thermostat.
Inspire Home Automation will not accept any liability whatsoever for damage caused to your central
heating system and/or electrical system as a result of the incorrect wiring of the thermostat. Also
damage to the thermostat due to incorrect wiring is not covered by your guarantee.
If you are in any doubt whatsoever about the wiring, we strongly recommend that you consult
a qualified electrician or heating engineer.
1. Identify the Live and Switched Live wires.
2. Make all wires that are not used for this installation safe.
3. Prepare the two wires to be connected by striping 5mm off the wire ends.
4. Connect the Live and Switched Live wires to your Inspire Thermostat and tighten
the connector screws.
5. Check the wires are secured in your Thermostat by gently tugging on them. If they
stay in place they are secure.
6. Make sure no bare wire is out of the connector block. If bare wire is showing
remove the wire and cut a small part of the bare wire off. Re-insert and connect
the wire.
7. Fit and screw the wiring cover to the wall mount using the supplied screws.
Important
•
Ensure you do not breach the earth continuity of the
circuit.
•
Ensure the circuit is protected by a 3 amp fuse.
CAUTION: High Voltage Wires
