Inspire Dual Lat/Row, Руководство по сборке и эксплуатации, Страница: 17 / 31

Page 14
Step 12: Attach one end of a spring to the eyelet and the other end to the hole in the plate at the bottom
of Upright 1. Insert the bolt end into the hole in plate on the Guide Cable Support. Make sure
there is one jam nut on the bottom side the plate and the other jam nut is on the top side of the
plate. Tighten the top jam nut just enough to make the Guide Cable tight. Tighten the bottom
jam nut against the bottom of the plate so the bolt will not come loose during use. Remove the
black Plastic Bushings from the Floating Pulleys, place Plastic Bushings around Guide Cables and
reinstall the Plastic Bushings into the Floating Pulleys.
Step 13: Attach Rear Shroud Plate Support to Main Frame
and Upright 1 using:
1 – M8 x 100 Hex Bolts
2 – M8 Flat Washers
1 – M8 Locknuts
Optional: Insert M10 x 50 Fully Threaded Bolt from Step 20 to hold Rear Shroud Plate Support in
place.
NOTE: Wrench Tighten Steps 2, 8, 9 and 13 Now .
Step 12
Step 13
1 - M8 x 100 Hex Bolts
2 - M8 Flat Washers
1 - M8 Locknuts
Install Guide Cable Supports
Guide Cables
Floating Pulley
Assembly
Rear Shroud Plate
Support
Springs
DUAL LINE LAT/ROW CABLE CHART
Cable lengths are in millimeters and for reference only.
Cable lengths could change at any time without notice.
Upper Cable p/n GM883-500-003
Guide Cable p/n GM883-500-001
Lower Cable p/n GM883-500-002