The wall outlet for your tank must have power supplied to it continuously
and must be fused. It should not be controlled by the same wall switch
that operates your disposer, unless using an InSinkErator SinkTop Switch
™
.
PREPARATION
START HERE
Identify locations for the tap faucet,
tank and filter (if applicable).
Check to make sure there is proper
clearance for tap handles to be
fully opened.
Check to make sure counter
is not too thick.
Make sure there is a grounded
electrical outlet under the sink.
Turn off water supply.
If using the sink sprayer hose hole,
remove nut that connects sprayer
hose at bottom of faucet.
Using adjustable wrench, remove nut
connecting sprayer washer flange in
sprayer hole.
Plug hose opening with either a
3.2mm plug or a 6.4mm cap
(not supplied).
a
b
If you have to drill through sink or
countertop, you may need to rent or
purchase the appropriate tools.
Consult a professional before drilling into
a surface other than stainless steel.
C
What if you don’t have a sprayer hole
or don’t want to use it?
Many homeowners replace the
soap dispenser in their sink with
an instant hot water tap.
If drilling a hole into a stainless steel
sink or counter top, you can cut a
mounting hole for the tap with a
hole saw for stainless steel, or you
can use a hole punch.
Required Hole Size
32mm- 38mm
Dependent on model
Required minimum from
center of hole to wall
67mm
Maximum counter
thickness (depth)
76mm
1
5
4
OVERVIEW OF A COMPLETED SETUP
