Insinger GS 302, Техническое руководство

Страница: 11 / 47

Undercounter DOC GS 302 1.0 05 www.insingermachine.com 800-344-4802
HOW THE DISHWASHER WORKS
When the machine is switched on, the booster
and wash tank fill and are heated to operating
temperature. The program button (6) is lit red
during heating. The booster preheats the wash
water before pumping to the wash tank. This
preheat/pumping sequence takes about 6-8 cycles
(about 30-45 minutes) before filling & heating the
wash tank.
•
Switch on machine by pressing button 1.
•
The tank is filled in stages by way of the boiler:
•
The boiler is first completely filled until the
electronic level control switches off.
•
The boiler heats up.
•
The tank is filled by way of the rinse pump for a
certain period of time.
•
When the boiler is filled again heated up, the tank
is again filled for a certain period of time by way
of the rinse pump.
•
This continues until the target values (level,
temperatures) for boiler and tank are reached.
•
During filling, button 3 glows red and the
temperatures of the tank (in Display B) and the
boiler (in Display A) are shown.
•
When the target values (level, temperatures)
have been reached, the temperature display
goes out and button 3 is lit green.
PART 3 OPERATING INSTRUCTIONS
9
WARNING:
Do not open the door while the program is
running. There is a risk of hot water spraying
out of the machine. (The unit is equipped
with a door safety switch, located behind the
door.)
!
CAUTION:
Do not place anything on the open door.
®
As soon as the target temperatures are reached,
(wash water approximately 150°F; final rinse water
approximately 180° F) the washer is ready for
operation. The program button (6) then lights up
green.
The machine is operated using fully-automatic
programs. These consist of three steps: washing,
draining and rinsing. The program button (6) is lit
blue during the wash and rinse cycle and green
when it is finished & ready for another load. It is lit
red when it is
Washing: The wash pump circulates the wash
water from the tank onto the dishes and ware
via the wash arms and jets. As the wash water
circulates, it constantly passes through a filter
system and the patented Mediamat Cyclo
(removing foreign particles from the water).
Detergent is added by means of an integral dosing
pump for liquid detergent. It is dosed from the
storage tank behind the front panel.
Draining: After washing, there is a brief pause to
allow the wash water to drain off the ware and to
reset the water level for the next run.
Rinsing: In the final step of the program, the
cleaned dishes are rinsed with fresh hot water to
remove any detergent residue and to heat up the
dishes for optimum drying outside the machine.
The rinse water also replaces the wash water. An
integral dosing pump doses the rinse aid from a
storage tank behind the front panel.