Insinger GS 302, Техническое руководство

Страница: 9 / 47

Undercounter DOC GS 302 1.0 05 www.insingermachine.com 800-344-4802
PART 2 INSTALLATION INSTRUCTIONS
7
CAUTION:
Note all the information on the enclosed connection
diagram. For the machine to work correctly,
the required water pressure and flow rate must be
guaranteed at all time.
CAUTION:
Protect the washer against frost. Systems that carry
water can be damaged if they freeze.
INSTALLATION AND CONNECTION
Connection to the Water Supply:
•
Use a ball valve for the water supply and drain
near the washer and in an easily accessible
position. It should not be located behind the
washer.
•
Use the hose and dirt catcher strainer (PART
NO. 80002153) provided with the washer to
connect it to the water supply. The filter must
be installed.
•
The washer is equipped with a drain pump.
The maximum drain pump lift above floor is 24”.
Connection to the Power Supply:
Before using the washer, check that all electrical
protection systems are working correctly.
Attention: The machine should not be regarded
as isolated from the power supply unless
switched off at the customer’s main switch.
WARNING:
Installation and connection of the washer to
the customer’s water inlet, waste water
drainage and electric connections are to be
carried out in accordance with national and
local criteria by qualified engineers.
!
Check for Completeness:
After unpacking the machine, first check the delivery
against the packing slip to ensure that it is complete,
and inspect for damage that may have occurred
during transportation. Immediately report any
damage to the carrier, the insurance company and
the manufacturer.
Setting Up and Alignment:
When setting up the machine, remember that the
machine gives off steam during operation (when
you open the door). Protect adjacent wooden furni-
ture to prevent it absorbing moisture and swelling.
The machine must be completely level prior to
installation. Adjust the machine’s feet to compen-
sate for any unevenness of the floor.
®
WARNING:
Do not connect a 208V machine to 240V
service or visa versa. Connect machine to
labelled power.
!
•
The total amp load of the washer depends on the
electrical characteristics; 208 Volt single phase 60
Hz equals a load of 27.4 fla, 240 Volt single phase
60 Hz equals a load of 25 fla. (This data is also
shown on the machine’s rating plate.)
•
The electrical connection of the washer is to be
fused by the customer with time-lag fuses or circuit
breaker according to wattage (see the machine rat-
ing plate). No other appliances may be fused with
the washer.
•
Install according to regulations, an isolator or a
control switch and a residual current circuit-breaker;
the 208 Volt unit requires a 35 amp circuit breaker
and the 240 volt unit requires a 30 amp circuit
breaker in the electric supply. These switches
must switch off all poles and have at least 3 mm
contact distance. The place of installation must be
near the washer and easily accessible.
•
Connect the power cord to the customers power
system. Note voltage of machine (either 208 volt or
240 volt) and connect power cord to the appropriate
supply. (The power cord can be wired directly into
the customers power supply or a plug may be
added to the end of the cord. The ground wire is
green, neutral is white and live is black.) make sure
the unit is properly grounded.
•
The power cord comes attached from the factory, if
replacement is required note: the ground wire (PE)
is yellow-green, the neutral conductor (N) is blue
and the live wires (L1, L2, L3) are black or brown.
Final Tasks:
The washer must be connected to all services (electricity
supply and to the fresh water and waste water systems),
prior to testing the machine & installation.