Insinger Eliminator 900, Техническое руководство

Страница: 12 / 44

Pulper DOC PULPER 1.0 06
www.insingermachine.com 800-344-4802
10
Mechanical connections
The pulper and extractor are supplied with adjust-
able leveling feet and rubber vibration isolation
pads. The machine should be set on the floor with
the pads under all feet and leveled prior to bolting
to the floor.
PART 2 GENERAL OVERVIEW—INSTALLATION
Chemicals
The pulper is supplied with a pre-wired and mounted
ready to use deodorizer or defoamer dispenser.
Upon completed installation of the pulping system,
contact a local chemical supplier for the correct
chemicals for your area.
Note: A proper detergent/deodorant combination is
recommended. This will ensure a clean, odor free
system.
CAUTION:
As with any 3 phase wiring system, an electrician
should check all motors for proper phasing. Pump
should be rotating in the direction indicated by arrow on
housing. Also, pulper and extractor should be rotating
CCW when viewed from above.
INSTALLATION INSTRUCTIONS
Eliminator 900
Waste Handling System
Electrical Connections
The pulper comes pre-wired (single point connection)
to a junction box that is mounted on the machine.
All machine devices are wired to this junction box.
Also, the machine is supplied with a wall mounted
electrical enclosure. The electrical connection for
this single point set-up requires running a conduit
from the J-Box to the enclosure and terminating as
shown on the installation drawing.
þ
NOTE:
The main power feed (by customer)
must be made to a circuit breaker or fused
disconnect as required by local codes.
þ
NOTE:
A wiring diagram is provided inside
the control panel and should be returned
when finished.
Main Electrical Enclosure
The main electrical enclosure is designed to be
mounted on a wall according to local codes or as
shown on installation drawing.
þ
NOTE:
Floor should be minimum 4” thick
concrete for accepting the recommended 3/8
inh diameter anchors. All feet should be
bolted to the floor with vibration pads under
each foot.
þ
NOTE:
Do not reduce the size of the lines
as shown on the installation drawing. All
lines are sized to facilitate necessary flows,
pressures, etc.
Connect hot and cold water supply to the supplied
connections as labeled. The connections supplied
are shown on the installation drawing.
Connect from the drain line to the floor sink as
shown on the installation drawing. IT IS
STRONGLY RECOMMENDED THAT CLEAN OUT
PROVISIONS ARE MADE IN THE DRAIN LINE.
Small ‘fines’ are generated in the pulping process
and in some case may slowly clogged drain lines.
þ
NOTE:
Provide Clean Out Connections in
the Drain Line.