Insinger Eliminator 900, Техническое руководство

Страница: 14 / 44

Pulper DOC PULPER 1.0 06
www.insingermachine.com 800-344-4802
12
PART 3 OPERATION & CLEANING PROCEDURES
CLEANING PROCEDURES
Daily
The following procedures should be done daily, at
the end of the shift and between meal times where
applicable.
1.
While pulper is running in full Auto, turn the
selector switch to OFF. The unit will run
through the automatic spray cycle.
2.
When the unit stops open the main drain valve
to allow all water to leave the system.
3.
Open the pulper doors and LOCK-OUT electri-
cal power at the electrical panel.
4.
Remove any debris left in the pulper.
DAILY OPERATOR CHECKS:
1.
During machine operation check for proper wa-
ter level and flow balance. If water level is in-
correct or fluctuating refer to water level set-up
procedure below.
2.
Insure that there is no debris or fouling matter
on the level probe. Clean daily.
þ
NOTE:
Be careful of sharp metal and
glass left in the pulper when cleaning out
the tank.
5.
Spray down the pulper and extractor interiors,
paying particular attention to the extractor
screen and Level Probe and pulper cutting
mechanism.
6.
Wipe down the exterior of the equipment.
þ
NOTE:
The level probe must be kept clean
of debris and fouling matter in order for the
machine to operate properly.