Maintenance
INOXPA S.A.U.
·
01.611.30.08EN · (0) 2020/02
17
When installing the different parts and seals, use soapy water to allow them to slide better.
B. Heavy duty transmission (only optional for KIBER KSF)
Disassembly
•
Loosen the nuts (54) and remove the leg (07) and the discharge nozzle (34).
•
Pull out the tie bars (29, 29A) and then remove the stator (22). If necessary secure the rotor (21) by holding
the shaft complement (26).
•
Remove the screws (52) and the washers (53).
•
Pull out the pump casing (01, 01A) from the front side.
•
Remove the safe rings (30), the transmission shield bushing (17A) and the bolts (27), so that the rotor (21)
and one end of the connecting rod (24, 24A) come out.
•
Proceed likewise on the other end of the connecting rod in order to remove it.
Assembly
•
Place the O-ring (81) on the shaft complement (26) and on the connecting rod (24), and the seals (80A) on
the transmission bushing (43).
•
Place this bushing on the shaft complement (26) and place the drive bolt (27) and the bolt for the connecting
rod.
•
Place the transmission shield bushing (17A) on the bushing (43) and fasten it with the safe rings (30).
•
Proceed likewise with the rotor on the other end of the connecting rod (21).
•
Mount the pump casing (01) and fasten it with the screws (52) and the washers (53).
•
Introduce the stator (22) lubricating it with soapy water and if necessary secure the rotor (21) by holding the
shaft complement (26).
•
Mount the discharge flange (34) and the leg (07) and fasten it with the nuts (54).
ATTENTION
0
1
.6
1
1
.3
2
.0
0
0
8
