innove duralam INTEGRA, Руководство по эксплуатации

Страница: 14 / 32

14
MAIN POwER swITch
• Located at the back of laminator
• Move switch to ON (I) position to turn main power on
• Move switch to OFF (O) position to turn main power off
cONTROL PANEL
Turn dial to adjust roller temperature to desired setting.
Refer to film manufacturer for correct settings.
NOTE:
Most films run well at top heat setting. If low melt film is
used a lower setting may be required.
“Auto-off” LED lights when laminator automatically
switches into this mode after 60 minutes of non–use.
NOTE:
3 hours or bypass settings can be set by trained technicians.
NOTE:
Auto-off feature only works when laminator is set at
80 degrees Celsius or higher.
Green “Ready” LED is on when roller temperature is
ready. Flashes if roller temperature is too hot.
Red “Power” LED is on when laminator is plugged in
and main ON / OFF switch is in the “ON” ( I ) position.
sPEED - Turn dial to adjust roller speed.
sTOP - Stops rollers.
RuN - Activates rollers.
REVERsE - Press once to stop rollers. Press and hold to
reverse rollers to clear out jams.
NOTE:
Safety Back–up
Beeper sounds when reversing.
CONTROLS AND FEATURES