Copyright InnovaPrep LLC
www.innovaprep.com 15
1.
Place the sample cup on a stable surface.
Invert the filter and snap onto the
sample cup firmly.
2.
Snap the elutor cap onto the filter firmly
to fully seat.
3.
Press the stem of the elution fluid
canister into the elutor cap, as shown in
Figure 4.16 until all the foam has been
expelled. The foam quickly collapses into
a liquid in the sample cup and available
for sample processing and analysis.
C
LEANING THE
S
YSTEM
Common off-the-shelf alcohol or bleach wipes can be used for cleaning
and disinfection.
Using gloved hands, remove the sampler from the work area, hot zone,
or contaminated area to an area where the cleaning can be safely
performed, if applicable, and disconnect the AC power converter and/or
remove the battery.
Wipe down the exterior surface of the inlet. To clean under the inlet,
use a swab to get the wipe under the inlet cap and wipe down the
interior surfaces of the sampler.
B
ATTERY
C
HARGING
The battery charger
consists of two parts, the battery cap and a “wall
wart” style AC power adapter, permanently connected by a flex
ible
cable. The AC power adapter is supplied with a standard North
American AC plug installed. Other AC plugs are available for
International use; contact InnovaPrep for more information. Plug the AC
power adapter into any available AC mains socket. The LED on the
power supply will illuminate, and the battery cap indicator will indicate
the Stand-by state (see below). Make sure that the connector and
contact pads on the battery are clean and free of foreign matter, and
FIGURE 4.11 AIRPREP
FILTER & ELUTION KIT
