Innova XTIRPA IN-8002, Инструкция и руководство по безопасности, Страница: 17 / 24

MU8002-012ENEU rev03 17
WARNING:
The integrated mast on the manhole guard must be positioned at the highest
point of the area to be barricaded.
IMPORTANT: When attaching the EN 361-compliant safety harness with the lifeline cable
or rope, it is imperative, in order to avoid the manhole guard toppling over, that the user tie
himself at the front of the XTIRPA system, where the door opens.
IMPORTANT: An EN 361-compliant fall protection harness is the only body support device
allowed to be used for fall protection.
WARNING: The Manufacturer’s Instruction and safety manual must be followed for proper
use and maintenance of this product. Alterations or misuse of this product or failure to fol-
low instructions may result in serious injury or death, for which the Manufacturer disclaims
all warranties and liabilities whatsoever, user, owner and purchaser of the XTIRP
A
system
waiving all claims, rights and recourses against the Manufacturer derived therefrom.
WARNING: The entire system must be immediately removed from service: if the safety of
the system is in doubt or the system has stopped a fall. It is imperative not to use the sys-
tem until a competent person has authorized (in writing) the reuse of the system.
WARNING: For all fall protection devices, it is essential, for safety purposes, that anchor-
ing device is always positioned correctly and that the task to be performed should be done
in a manner to reduce risk of fall and height of fall. The anchoring point and fall protection
device must be placed directly over the user’s position.
WARNING: With the use of a fall protection device, it is essential for safety purposes, to
verify the free space required under the user at the work site before each use to avoid and
prevent falls, in case of collision with ground or any other obstacle that could be in the path
of the fall.
WARNING: The XTIRPA system must only be used with adaptors, anchors, connectors
(EN 362), pulleys and other components, parts or sub-systems certified, approved and
recommended by the Manufacturer. Any substitution or replacement of adaptors, anchors,
connectors (EN 362), other components, parts or sub-systems may be incompatible, may
jeopardize the security and reliability of the entire XTIRPA system and may lead to serious
injury or death, for which the Manufacturer refuses any warranty or responsibility, the
user, owner and buyer of the XTIRPA system waiving any arising claim, right and remedy
against the Manufacturer. All connectors (EN 362) (hooks, snap hooks, D-rings) must
meet the standard EN 362.